Description

Metal Plus Swivel Bar for Standing Seam Roof Anchors

The Metal Plus Swivel Bar is an engineered anchorage connector designed to join two identical Snap-On Safety Anchors (SOS) across adjacent standing seam roof panels. It creates a horizontal anchorage configuration intended to distribute load between paired anchors, subject to the structural limitations of the roof system.

The Swivel Bar is not a standalone anchor and must be used only with compatible Metal Plus SOS anchors

Engineered Load Distribution for Snap-Lock Systems

Many standing seam anchorage systems claim broad compatibility across panel types. The Swivel Bar was developed to provide a controlled, manufacturer-approved method of connecting two identical SOS anchors.

When properly configured:

• The Swivel Bar distributes load between two anchors
• All fall protection connectors must attach only to the central 360° anchorage eye
• The D-rings on individual anchors must not be used while the Swivel Bar is installed

Use with mismatched anchor models, modified anchors, or non-Metal Plus components is prohibited

Adjustable Width for Multiple Panel Configurations

The Swivel Bar adjusts continuously from:

• 21½ inches down to 8 inches
• No tools needed for adjustment, simply swivel into place

This allows compatibility across a range of standing seam panel widths within those limits.

OSHA Compliance & System Requirements

When installed in accordance with Metal Plus instructions and when the anchorage and supporting structure are evaluated and approved by a Qualified Person, the Swivel Bar’s 360° anchorage eye is intended for use as part of a fall arrest system designed to comply with:

• OSHA 1910.140
• OSHA 1926.502(d)(1)

All inspection, training, fall-clearance, and rescue planning requirements applicable to the SOS Anchor apply equally to the Swivel Bar system

Installation Requirements

Proper installation is critical for compliance and safe operation.

Key Installation Details

• Must be fully assembled with anchors prior to roof installation
• Swivel Bar fasteners torque to 20 ft-lbs
• Anchor fasteners must be torqued per SOS Anchor installation manual
• Use only two perimeter mounting holes on each anchor when Swivel Bar is installed

Full installation procedures are detailed in the official Swivel Bar Installation Manual

Swing-Fall & Clearance Considerations

The Swivel Bar creates a horizontal anchorage configuration that may increase swing-fall exposure and fall-clearance requirements compared to a single anchor system.

Prior to use, a Competent Person must evaluate:

• Roof geometry
• Edge distances
• Swing-fall path
• Total fall clearance

Inspection & Maintenance

• Inspect prior to each use
• Formal inspection every three (3) months by a Competent Person
• Remove from service if damaged or if factory pivot fasteners loosen beyond specified tolerance